Cold method pulley lagging manual:
Application order:

- completely delete an old gumming.

-Clean out the pulley surface with sandblast or polishing and cleanse with NILOS cleaner.

-Cover a degreased and mechanically cleaned surface with Primer SH and let it to dry up .

-Adapt a rubber lagging by length and width. Rough and cover with TL-T70 glue a sticking bead first and let the glue to dry up.

-In depend of joint area method and rubber filler TS, rubber filler + lagging or special sealant material.

-Dried up primer on pulley surface cover with TL-T70 1 layer and let to dry up.

-Cover a lagging contact layer with RL-T70 and 2nd layer on pulley surface.

-After glue dryness fraction testing by palm backside method (hairs must stick a tiny bit)) Put a lagging on a pulley surface at the right angle and stitch with a roller, Air bubbles appearance is inadmissible.

-Processing

-Start using at least after 4 hours.

Old lagging deleting:

а) old lagging could be deleted on a lathe.

b) lagging deletenig alternative

NILOS hand siriper for lagging deletion

Feature

power:	900 W, 230V/50 Hz
working width:	120mm
weight:	3,1 kg

Advantages:

control simplicity

fast knife change

easy to delete lagging rom the pulley

Aluminium pincher for lagging edges seizure and tension

Removeable knife with holder

Applications chain:

-Cut old lagging on 120mm width strips across the pulley untill the steel surface

-Delete old lagging with the help of pincher.

-It is comfortable to work with device. Lagging can be deleted directly from the pulley.

-Delete old rubber remains by rough disks. Pulley steel surfaxe must be clean.

Old lagging deletion by device

Pulley lagging

To the mainpage